česky  čs
english  en
Engineering Design II. (E131002)
Departments:ústav konstruování a částí strojů (12113)
Valid until: ??Range:2P+3C
Theoretical fundamentals of GPS (Geometrical Product Specification). Students will get critical knowledge about ISO system of limits and fits, tolerancing, surface texture, geometrical tolerance, dimensional loops, tolerancing of angles and cones, tolerancing of threads. Integral part of course is a project where students apply and practice their knowledge from lectures.
Ing. Martin Dub Ph.D.
Letní 2023/2024
Ing. Martin Dub Ph.D.
Letní 2022/2023
Tolerancing of longitudinal dimension
ISO system of limits and fits (Interchangeable system)
Tolerancing of surface texture
Geometrical tolerance
Dimensional loops
Tolerancing of angles and cones
Tolerancing of thread
Gradation of quantities - series of preferred numbers
Structure of tutorial
Representation and dimension of gears and splines
Joint of a hub and a shift
Design of spindle shaft
Calculation of dimension loop
Křivý, J., Pospíchal, J.: Fundamentals of design I, English texts
Křivý, J. : Fundamentals of design II - Rules of Interchangeability, English texts
Rolling bearings. SKF Main Catalogue. PUB BU/P1 10000/2 EN. August 2013 (EN)

Basic rules of representation and dimensions of parts. (Engineering Design I)
Tolerances, Deviations, Geometrical tolerance, Surface Roughness, Threads, Dimension loops, GPS.
data online/KOS/FS :: [Helpdesk] (hlášení problémů) :: [Reload] [Print] [Print wide] © 2011-2022 [CPS] v3.8 (master/18fbb08a/2024-05-30/02:31)