česky  čs
english  en
CAD 2 (E136032)
Departments:ústav konstruování a částí strojů (12113)
Abbreviation:CAD 2Approved:19.10.2009
Valid until: ??Range:0P+2C
Semestr:*Credits:2
Completion:ZLanguage:EN
Annotation
Course follows Course Autodesk Inventor I. It is focused on usage of advanced and specialised tools in CAD Inventor. Students may use taught skills in courses like ED II, III and IV
Structure
Parametric modeling, Adaptive modeling (components), Creation of assembly, Generation of part list, Designing of shaft, Drive constraint, The parameters used for many components, Intelligent assembly with using skeleton, Derived assembly, Creation of gear drive and belt drive (+ control), Designing of frame, Creation of weldments
Structure of tutorial
1) Welded Assemblies
2) Sheet metal parts
3) Introduction into parameters in AI, derived parts
4) Advanced Techniques of parametric modelling
5) i-mates, i-parts, i-assemblies
6) Design Accelerator
7) Exploded Assemblies - Presentation
8) Free modelling, Plastic components
9) Inventor Studio
10) Assessment
Literarture
AUTODESK, Inc.: Autodesk Inventor 2008, San Rafael, California, 2008
BANACH, D; JONES, T; KALAMEJA, A: Autodesk Inventor 2009 Essentials Plus, Autodesk Press
JONES, T; KALAMEJA, A: Autodesk Inventor 2009 Essentials Plus, Autodesk Press
Requirements
Knowledge of Autodesk Inventor I
Keywords
Inventor, CAD, 3D, model, design, SEPS
data online/KOS/FS :: [Helpdesk] (hlášení problémů) :: [Reload] [Print] [Print wide] © 2011-2022 [CPS] v3.8 (master/7df5d77f/2024-09-06/11:38)